Conair HTC 120, User Manual, Page: 47 / 330

Installing the Cyclone
(optional)
The optional cyclone separator is designed to be mounted to the return air outlet of
the CH Hopper.
IMPORTANT:
The optional cyclone is designed to be connected to the return air cir-
cuit of the CH Hopper, then connected to an optional dust collector or to the dryer’s
air inlet.
To install the cyclone to the CH Hopper:
1
Using a forklift, hoist or crane, raise the cyclone’s mounting bracket to its
installation location on the side of the CH Hopper.
Installation location
depends upon your system setup.
2
Remove the five (5) bolts located on the top of the lid of the hopper. The
removal of the five (5) bolts is dependent upon the installation location of the
cyclone.
3
Remove the five (5) bolts located on the hopper upper section or hopper
door section of the hopper.
The removal of the five (5) bolts is dependent
upon the installation location of the cyclone.
CAUTION: To prevent accident and injury, move the cyclone separator to its mount-
ing location using a forklift, hoist or crane.
I n s t a l l a t i o n - G e n e r a l l
3-17
3
In
st
al
la
tio
n
Top Bolt
Pattern
Bottom Bolt
Pattern
(continued)
IMPORTANT:
Reference your
system layout drawings for
the correct cyclone bracket
bolt pattern usage before it
is installed.