![background image](http://html.mh-extra.com/html/conair/htc-120/htc-120_user-manual_2649067284.webp)
Cleaning the Dust Collector
(optional)
(continued)
6
Clean the dust collector filter using a vacuum.
If using a vacuum,
repeatedly apply the vacuum to the outside of the filter element until all
debris is removed. Replace the filter if it is damaged, worn or still clogged
after cleaning.
7
Install the filter
in the dust collector by aligning it on the stud then sliding it
up into the dust collector.
8
Secure the filter in the dust collector by installing the wing nut.
Tighten
the wing nut by hand to insure a tight fit at the top of the filter.
9
Reinstall the dust collector tank
by engaging the tank latch hooks on the
lock ring on the dust collector body. Once all for "hooks" are engaged, lift up
on the latches to secure the tank to the dust collector body.
CAUTION: Wear eye protection.
If you use compressed air to clean the equip-
ment,
you must wear eye protection
and observe all OSHA and other safety
regulations pertaining to the use of compressed air.
TIP:
If gasket on the filter
tank becomes loose or
detached from the filter
cap, resecure with high
temperature silicone adhe-
sive.
✒
5-34
l M a i n t e n a n c e
Summary of Contents for HTC 120
