Conair HTC 120, User Manual

Page: 102 / 330

3-72
l I n s t a l l a t i o n - C o n t r o l & C o m m u n i c a t i o n W i r i n g
Connecting the GasTrac RTD Sensor
The GasTrac RTD sensor monitors the temperature of the drying air as it enters the
CH Hopper. If the probe is not installed correctly, temperature readings will not be
inaccurate.
CAUTION:
Always disconnect and lock out the main power sources before making elec-
trical connections. Electrical connections should be made only by qualified personnel.
1
Disconnect and/or lock out main power to the GasTrac.
2
Route the GasTrac RTD cable to the GasTrac control center.
3
Plug the RTD cable into the GasTrac control center. Coil any excess cable
and secure with a wire tie.
NOTE: Conair recommends locat-
ing the RTD probe, when possible,
within 30 ft {9.15 m} of the
GasTrac control center.
✐
ON
O
O
FF
IMPORTANT:
Always refer
to the wiring diagrams
that came with your
GasTrac before making
electrical connections.