Problem
Dry Air Process Pressure
Sensor Alarm
Return Air Dew Point
Sensor Alarm
Possible cause
The pressure sensor is damaged or not
functioning properly.
Faulty wiring.
The dew point sensor is damaged of not
functioning properly.
Solution
Replace the pressure sensor.
Diagnose and correct wiring problems.
Refer to the wiring diagrams supplied
with the EnergySmart Drying System.
Replace the dew point sensor.
Diagnose and correct wiring problems.
Refer to the wiring diagrams supplied
with the EnergySmart Drying System.
6-26
l Tr o u b l e s h o o t i n g
Passive Alarms
If an alarm occurs, a red dialog box is displayed on the dryer’s touch screen
control. The dryer continues to operate, but this problem could prevent cor-
rect drying of your material. The dialog box will indicate whether the alarm
is a shut down alarm or a passive alarm.
Summary of Contents for HTC 120
