Conair HTC 120, User Manual

Page: 82 / 330

3-52
l I n s t a l l a t i o n - M a i n Po w e r C o n n e c t i o n s
Connecting Main Power to the
Dr yer
CAUTION:
Always disconnect and lock out the main power sources before making
electrical connections. Electrical connections should be made only by qualified
personnel.
1
Open the dryer’s electrical enclosure. Turn the disconnect dial on the dryer
door to the Off or “O” position. Turn the captive screw and swing the door open.
2
Insert the main power wire through the knockout in the side of the enclo-
sure or the rear of the dryer
(the dryer’s electrical wire connection location
was a factory option and may be connected through the front or the rear of the
dryer). Secure the wire with an appropriately-sized strain relief.
3
Connect the power wires to the three (3) terminals at the top of the power
disconnect holder.
4
Connect the ground wire to the ground lug as shown in the photo.
IMPORTANT: Always refer
to the wiring diagrams
that came with your
EnergySmart Dryer before
making electrical
connections.
ON
O
O
FF