![background image](http://html.mh-extra.com/html/conair/htc-120/htc-120_user-manual_2649067101.webp)
3
In
st
al
la
tio
n
I n s t a l l a t i o n - C o n t r o l & C o m m u n i c a t i o n W i r i n g l
3-71
Connecting the RTD Sensors
(HTC only)
(continued)
Process Protection RTD Probe
(continued)
CAUTION:
Always disconnect and lock out the main power sources before making
electrical connections. Electrical connections should be made only by qualified
personnel.
1
Disconnect and/or lock out main power to
the HTC.
2
Route the process protection RTD cable
from hopper inlet to the HTC control
panel.
Plug the connector into the recepta-
cle in the side of the control center labeled
“Process Protection”. Hand tighten the con-
nector. Coil any excess cable and secure it
with a wire tie.
ON
O
O
FF
IMPORTANT:
Always refer
to the wiring diagrams
that came with your HTC
before making electrical
connections.
Summary of Contents for HTC 120
