![background image](http://html1.mh-extra.com/html/ideali/tfi7-series/tfi7-series_instruction-manual_3632750001.webp)
TFI7-10340-700
TFI7
TFI7
CROYDONMAQ INDUSTRIAL LTDA.
Estrada São Lourenço, 891 - Capivari
Duque de Caxias- RJ / Brasil - CEP 25243-150
Phone: 55 21 2777- 8100 / Fax: 55 21 2777- 8106
e-mail: [email protected] - www.croydon.com.br
T
h
e
p
ic
tu
re
s/
d
ra
w
in
g
s
ar
e
ill
u
st
ra
ti
o
n
s.
A
ll
d
at
a
ca
n
b
e
ch
an
g
ed
w
it
h
o
u
t
n
o
ti
fi
ca
ti
o
n
.
ELECTRICAL FRYER - MODEL: TFI7-10340-700
-Please read these instructions carefully before operating this appliance.
-The temperature is thermostatically controlled between the range of 80
°
C to 200
°
C(176
°
F to 392
°
F). A
signal lamp adjacent to the thermostat indicates when the heating element is energized.
SAFETY
-This appliance is designed to operate on alternative current (A.C.) Only
-DO NOT CONNECT TO DIRECT CURRENT (D.C.).
-Care should be taken when operating this appliance, as HOT SURFACES may cause burns.
-
WARNING!
Hot oil can cause burns. Spilling oil can cause severe burns. Do not move fryer without
draining all the oil from the tank.
-Do not over fill baskets. Carefully load them into hot oil. A danger of surge boiling can also occur if the
food to be fried is excessively wet or the frying basket is too full.
-It is dangerous to use old oil as this can reduce the flash point and cause surge boiling.
-Ensure that power supply cord does not come into contact with hot surfaces.
-When not in use for long period unplug the appliance.
INSTALLATION AND OPERATION
-Before connecting your appliance check if voltage of your power system corresponds to the unit
label.
-Fill the container with 14.3 lbs (7 liters) of quality oil (fat).
-Set thermostat to desired operation temperature (see table 1) and pilot light will turn on. As soon
pilot light turns off, appliance has reached desired temperature.
-The basket should be filled up to 2/3 of the capacity.
-To turn off your unit turn knob completely towards left.
CLEANING PROCEDURE
-Always ensure that the appliance is disconnected from the main power supply before cleaning.
-Wait until oil cools and proceed as follows:
- Remove installation box.
- Remove oil container and empty the oil.
-Appliance should not be cleaned with a water jet or immersed in water. Use only a damp cloth or sponge
dipped in soapy water.
-Wipe off appliance with a dry cloth and wait at least half an hour before re-connecting to main power
outlet.
INSTRUCTION MANUAL