Problem
System Start Failed
System Stop Failed
System Cool Down Done
Dryer Blower Comms Read
Error
Possible cause
A component(s) within the EnergySmart
Dryer system has failed to start after a
system start.
A component(s) within the EnergySmart
Dryer system has failed to stop after a
system stop.
The EnergySmart Dryer system has
properly cooled down before shutting
down.
The variable frequency drive (VFD) on
the dryer has been turned off.
Faulty wiring.
Device did not accept the command.
Incorrect Modbus address.
Solution
Determine which component(s) within
the EnergySmart Dryer system did not
start and troubleshoot the component(s).
Determine which component(s) within
the EnergySmart Dryer system did not
stop and troubleshoot the component(s).
This is a normal operating condition.
Turn on the variable frequency drive
(VFD).
Diagnose and correct wiring problems.
Refer to the wiring diagrams supplied
with the EnergySmart Drying System.
Check the baud rate, data bits, parity and
stop bits (9600, 8, N, 1).
Correct the Modbus address.
See
Operation section entitled, EnergySmart
Dryer System Modbus Communications.
6-18
l Tr o u b l e s h o o t i n g
Passive Alarms
If an alarm occurs, a red dialog box is displayed on the dryer’s touch screen
control. The dryer continues to operate, but this problem could prevent cor-
rect drying of your material. The dialog box will indicate whether the alarm
is a shut down alarm or a passive alarm.
Summary of Contents for HTC 120
