![background image](http://html.mh-extra.com/html/conair/htc-120/htc-120_user-manual_2649067136.webp)
3-106
l I n s t a l l a t i o n - Te s t i n g
Testing the Primar y Receiver
(optional)
(continued)
6
Press the “Enable” button on the Primary Hopper Loader Screen
(Screen 5) to activate the primary receiver.
If everything is installed correctly:
•
The Positive Displacement Pump will turn on for the duration of the
load time set at this screen.
•
The purge valve will purge the conveying line leaving the CH Hopper
•
The discharge valve of the receiver will open at the end of the load
cycle time for the duration of the dump time set at this screen.
7
Press the “Disable” button on the Primary Hopper Loader Screen
(Screen 5) to deactivate the primary receiver.
If everything is installed correctly, the following sequence should occur.
•
The Positive Displacement Pump will turn off (unless idle mode
equipped)
•
The discharge valve of the receiver will close
•
The purge valve will deactivate (if supplied)
8
After the test has been completed successfully,
properly shut down the
dryer,
see Operation section entitled, Stopping the EnergySmart Dryer
System.
Summary of Contents for HTC 120
