MACDONALD INDUSTRIES LIMITED
INSTALLATION INSTRUCTIONS
MDAD
JDM APPLAUSE HOT AIR HAND DRYER
The hand dryer must be installed and maintained by a licensed electrician and is to
be installed according to national wiring standards.
STEP 1:
Remove the Hand Dryer Case from the base plate by unscrewing the two
socket head cap screws located in the lower surface using the T25 Torx drive bit supplied.
Remove the inlet grill by carefully unclipping the sensor lead from the printed circuit
board, carefully swing the housing away from the steel chassis at the lower edge and
then move it upwards until it is clear of the base unit.
STEP 2:
Survey the intended mounting location to
ensure a power source is available. The Hand Dryer
SHOULD NOT be mounted in close proximity of any
reflective surface. (300mm).
Note:
Installing the Hand Dryer above washbasins or bench tops may cause the
dryer to switch on automatically. If this is the case, the beam sensitivity distance will be
automatically reset after approximately 45 seconds.
STEP 3:
Once the Hand Dryer position is determined, refer to the installation detail on
the carton which outlines the mounting template and suitable mounting heights before
any installation or drilling is commenced.
Note:
Where a multiple dryer installation is being carried out, the dryer should be
spaced a minimum of 600mm apart, centre to centre.
STEP 4:
Securely attach the Hand Dryer unit to the wall using the appropriate hardware
(not supplied).
Stud Wall
– use 55mm Wood Screws
Brick Wall
– use 6 x 55mm Expanding Screw Plugs
Plaster Wall
– use 6mm Toggle Bolts
(Recommended bolt length is 55 long for walls less than 18mm build finish and 80mm
long for anything larger).
STEP 5:
Use the attached cable to make the required power connections. The connection
of the wiring must be made in accordance with the wiring standards and must include means
for disconnection, AS/NZS 3000. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Do not reverse the connections as it may damage the printed circuit board. (No
warranty shall apply) Do not switch power on until casing has been installed unless under
strict test control conditions.
