8-32
Cisco Catalyst Switch Manager User Guide
OL-4930-01
Chapter 8 Interface and Subinterface Management
GE-WAN Interface Management Window
Configuration Tab
The following areas are available on the Configuration tab of the GE-WAN Interface Management
window:
•
General
•
Layer 2
•
Layer 3
•
Private VLAN Edge
•
Actions
General
The General area provides the following information:
•
Duplex—Displays the duplex mode for the port. This attribute is read–only and should have one of
the following values:
–
full-duplex
–
half-duplex
•
Max. Input Queue Length—Displays the input queue length in packets.
•
Max. Output Queue Length—Displays the output queue length in packets.
•
Link Up/Down Trap—Indicates if link up or link down traps are being generated. This list contains
the following values:
–
enabled
–
disabled
•
Delay—Specifies the delay in tens of microseconds for an interface or network segment.
Note
The Delay attribute is an informational parameter used only to communicate the current delay
to the higher-level protocols (such as IGRP and EIGRP); you cannot adjust the actual delay of
an interface with this command.
•
Bandwidth—Overwrites default bandwidth in kilobits per second.
Note
The Bandwidth attribute is an informational parameter used only to communicate the current
bandwidth to the higher-level protocols (such as IGRP, EIGRP, and OSPF); you cannot adjust
the actual bandwidth of an interface with this command.
Layer 2
The Layer 2 area provides the following information:
•
MAC Address—Displays the MAC address of the interface.
•
MTU—The size, specified in octets, of the largest datagram (frame) that can be sent on the interface.
