2-14
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
Configuring MIDlets
Configuring MIDlets
To use the Enhanced Phone User Interface (MIDlets), your Cisco Unified IP Phone 7970/7975 must be
configured to run a new application service. This section explains how to implement the MIDlets
interface, which is available in Cisco TelePresence System (CTS) Release 1.5 and later releases.
The Cisco Unified IP Phone auto-configures the IP address of the CTS. The CTS obtains the phone IP
address using continuous data protection (CDP) data and CTS sends the command to the Cisco Unified
IP Phone to start the MIDlet. The launch command specifies the IP address of the CTS.
Before You Begin
Note
If you are upgrading from an older XML specification identifier (XSI) user interface to MIDlets, you
must reset the phone and reset the CTS to allow the Java MIDlets application to work with the
Cisco Unified IP Phone. See the
“Managing Phone Reset and Codec Connectivity” section on page 3-11
for reset information.
•
Turn off
Auto Answer
for the Cisco Unified IP Phone.
•
Enable the speakerphone.
•
Enable the PC port.
Note
You must have
MIDlets
installed on the Cisco Unified CM to use the 720p (Lite) feature. For more
information about 720p (Lite), see the
“Quality Per Display - 720p (Lite)” section on page 5-4
.
Procedure
This section contains the following configuration tasks:
•
Uploading Files to the Cisco Unified CM TFTP Directory, page 2-14
•
Creating MIDlets IP Phone Service in Cisco Unified CM, page 2-16
•
Configuring the MIDlets IP Phone Interface, page 2-17
•
Setting Phone URL Parameters for MIDlets, page 2-18
Uploading Files to the Cisco Unified CM TFTP Directory
Use the information in the following sections to upload files to the Cisco Unified CM TFTP Directory:
•
Downloading Cisco TelePresence MIDlet Phone Application .jad and .jar Files from Cisco.com,
page 2-15
•
Uploading Cisco TelePresence MIDlet Phone Application .jad and .jar files to Cisco Unified CM,
page 2-15
Handset/Headset Monitor
—
Disabled.
Enbloc Dialing
—
Enabled.
Table 2-10
Product Specific Configuration Layout Fields
Field
Required?
Setting
