1-30
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Assigning a Directory Number to the Cisco TelePresence Device
Parameters Used in Phone Field
To configure the Parameters Used in Phone Field, follow these steps:
Step 1
Enter the SIP Phone Port information using the information in
Table 1-14
as a guide.
Step 2
Click the Save button to save your settings.
Assigning a Directory Number to the Cisco TelePresence
Device
This section describes how to assign a directory number to the Cisco TelePresence device that you just
created in the
“Creating a New Cisco TelePresence Device” section on page 1-5
.
Perform the following tasks in the Cisco Unified CM Administration interface:
•
Configuring the Access Directory Number, page 1-31
•
Configuring the Directory Number for the Cisco TelePresence Device, page 1-32
Table 1-13
Phone Security Profile CAPF Information
Field
Required
Setting
Authentication Mode
Yes
Choices are:
•
By Null String
•
By Existing Certificate (precedence to LSC)
•
By Existing Certificate (precedence to MIC)
Key Size (Bits)
Yes
Choices are:
•
512
•
1024
•
2048
Note
These fields are related to the CAPF Information settings on the Phone Configuration page.
Table 1-14
Parameters Used in Phone Field
Field
Required
Setting
SIP Phone Port
Yes
This setting applies to SIP phones that are using UDP transport.
Enter the port number for Cisco Unified SIP IP Phones that are using UDP
to listen for SIP messages from Cisco Unified CM. The default setting
equals 5060.
Phones that are using TCP or TLS ignore this setting.
