6-20
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 6 Setting Up the Room to Use Cisco TelePresence Manager
Testing Cisco Unified CM with the Pre-Qualification Assistant
Testing Cisco Unified CM with the Pre-Qualification Assistant
Note
For complete Pre-Qualification Assistant installation and operating instructions, see the Configuring
Cisco Unified Communications Manager for Cisco TelePresence Manager chapter of the
Cisco TelePresence System Manager
administration guide on Cisco.com.
Install and run the Pre-qualification Assistant to ensure that your pre-installation set up is performed
correctly. The data you enter into the Tool Test Configuration forms are used to verify connections to the
servers and get data from them in order to configure CTS Manager
Figure 6-1
shows the Cisco Unified CM test window that allows you to test the Cisco Unified CM
configuration. The Cisco Unified CM Test Configuration form requires the same data for all three
network environments.
Table 6-3
describes the fields found in the Cisco Unified CM Test Configuration
form.
Figure 6-1
The Cisco Unified CM Test Configuration Form
Table 6-3
The Cisco Unified CM Test Configuration Form Fields
Field Name
Field Value
Host
Hostname or IP address of Cisco Unified CM
1
1.The Cisco Unified CM Host field in the Cisco TelePresence Manager System
configuration uses only IP addresses in a non-DNS environment. If DNS is
configured and accessible, use either hostname or IP address.
Bind Mode
Always set to secure mode.
Port
Always set to port 8443.
Username
Logon account with Cisco Unified CM
Administrative privileges.
Password
Password for Cisco Unified CM Admin account.
Certificate
Full path name to the Cisco Unified CM security
certificate.
