1-6
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Configuring a Cisco TelePresence Device
Configuring a Cisco TelePresence Device
Note
You must restart your system after you have completed the configuration tasks in this section. See
Saving
Your Settings
for more information.
To configure a Cisco TelePresence device, perform the tasks in this section. When you are finished
configuring your settings, click Save and follow the prompts to restart the system.
Before You Begin
In the Phone Configuration window, verify that the Phone Type and Device Protocol lists contain the
following information:
•
Phone Type—Cisco 7970 or Cisco 7975
•
Device Protocol—SIP
Procedure
The following sections describe how to configure Cisco TelePresence devices and associated parameters:
•
Device Information, page 1-6
•
Protocol Specific Information, page 1-8
•
Certification Authority Proxy Function (CAPF) Information, page 1-9
•
MLPP Information, page 1-10
•
Product Specific Configuration Layout, page 1-10
•
Saving Your Settings, page 1-26
Device Information
To configure device information, enter information into the fields using the information in
Table 1-1
as
a guide. Click Save to save your settings.
Table 1-1
Device Information Window
Field
Required?
Setting
Registration
—
Read-only. Indicates whether the system is Registered with Cisco Unified
Communications Manager and lists the registered Cisco Unified CM address.
IP Address
—
Cisco Unified IP Phone IP Address. Click on the address to see information for that
phone in a new window.
Active Load ID
—
View-only field showing the status of the active load.
Note
Available on the Cisco Unified IP Phone but not available on the CTS.
MAC Address
Yes
MAC address for the Cisco TelePresence primary codec.
Description
—
Short description of the device.
