2-8
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
Configuring the Cisco Unified IP Phone
Expansion Module Information
Table 2-4
describes fields found in the Expansion Module Information section on the Phone
Configuration page. Leave all fields unchanged.
External Data Locations Information
Define the server locations for external data using the information in
Table 2-6
as a guide.
Observe the Following:
•
The server designation can be either the IP address or the hostname of the Cisco TelePresence
device.
Note
If a server hostname is used, it must be resolvable by the Cisco Unified IP Phone 7975.
•
The format for each required field is http://server hostname: or IP address: Followed by the 8080
port address, then a slash and one of the following, depending on the field:
–
services.html
–
getservicesmenu.jsp
–
authenticate.html
–
idle.html
•
Leave fields in the External Data Locations Information table blank to use the default settings.
Note
For information about configuring the phone with Cisco Unified CM firmware release 8.0, see
“Configuring the MIDlets IP Phone Interface” section on page 2-17
.
Note
Be careful when typing URLs to avoid typos.
Table 2-4
Expansion Module Information
Field
Required?
Setting
Module 1
—
<None>
Module 1 Load Name
—
Leave blank.
Module 2
—
<None>
Module 2 Load Name
—
Leave blank.
