1-25
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Configuring a Cisco TelePresence Device
SNMP Trap Receive Parameters
Table 1-11
lists the preset SNMP trap receiver parameters that are associated with the
Cisco TelePresence device.
Note
Using the information in
Table 1-11
as a guide, you can set up to five trap destinations.
Table 1-11
Cisco TelePresence SNMP Trap Receiver Parameters
Field
Required?
Setting
SNMP Trap Receiver 1
SNMP (v3) Trap Receiver
Address
—
IPV4 IP address or hostname of the SNMP trap receiver (the remote SNMP
system) where SNMP traps will be sent. Maximum field length is 64
characters.
SNMP (v3) Trap Username
—
SNMP v3 only. Username used to access the system where SNMP traps are
received. Maximum field length is 32 characters. Username must begin with
a letter.
Note
You cannot use “admin” as an SNMP trap username.
SNMP Security Level
Yes
SNMP v3 only. Level of security supported by the SNMP Trap Receiver.
Possible field values are:
•
(v3) No Authentication, No Privacy (default)
•
(v3) Authentication, No Privacy
•
(v3) Authentication, Privacy
•
(v2c) Notification
SNMP (v3) Auth. Algorithm
Yes
SNMP v3 only. Choose from the following authenticated algorithms:
•
MD5
—Message-Digest algorithm 5
•
SHA
—Secure Hash Algorithm
SNMP (v3) Auth. Password
Yes
SNMP v3 only. Password used to gain access to the SNMP server associated
with the Cisco TelePresence system. Default password is snmppassword.
•
Maximum field length is 32 characters.
•
Minimum field length is 8 characters.
Note
Each algorithm requires different privacy and authentication
passwords.
SNMP (v3) Privacy Algorithm
Yes
SNMP v3 only. Choose from the following privacy algorithms:
•
AES
—Advanced Encryption Standard
•
DES
—Data Encryption Standard
