3-5
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 3 Verifying and Troubleshooting the Cisco TelePresence System Configuration
Troubleshooting Your Configuration
MIDlet upgrade hangs,
shows the following
message:
“Error contact
administrator”
MIDlet Upgrade Issues
The phone firmware is unable to uninstall the
older version cleanly to make way for the
new version. The issue happens during
upgrade of the MIDlet if the phone is not
reset after the upgrade.
Reset the phone after upgrade.
See the
“Managing Phone Reset and Codec
Connectivity” section on page 3-11
for reset
information.
See also
Managing Cisco Unified IP Phones
in
Chapter 2, “Configuring the Cisco Unified IP
Phone for MIDlets”
for information about
configuring external URLs.
MIDlet fails to initialize
properly, showing the
following message:
“Configuration error.”
Authentication Issues
The MIDlet does not find Authentication
Server URL or it does not recognize its
format.
Supported Character Issues
Non-English characters are used on phone
device profile.
1.
Properly configure the Authentication
Server URL for the phone
2.
Click Save.
3.
Reset the phone.
Tip
Use only English characters.
See
Managing Cisco Unified IP Phones
in
Chapter 2, “Configuring the Cisco Unified IP
Phone for MIDlets”
for information about
configuring external URLs.
See also the
“Managing Phone Reset and
Codec Connectivity” section on page 3-11
for
reset information.
CTS was moved to a different
Cisco Unified CM and the
registration is rejected.
CTL File Issues
The CTS was associated with a different
secure Cisco Unified CM at one time and the
CTS preserved the previous Certificate Trust
List (CTL) file.
Remove the CTL file from the administration
interface.
The Cisco TelePresence unit
does not register.
CTS Unknown Issues
Cisco TelePresence System could be
unknown:
•
Cisco Unified CM does not know about
the CTS.
•
CTS is not registered because it is
unplugged.
•
CTS MAC address is entered incorrectly.
1.
Test the network connection to the master
codec by doing the following:
a.
Plug the codec network cable directly
into the CTS Cisco Unified IP phone.
b.
If the IP address displays, the problem
is with the codec.
2.
Verify the phone registration by doing the
following:
a.
Log in to the Cisco Unified CM
administration interface.
b.
Click on the IP address and verify the
phone registration.
Table 3-1
Troubleshooting the Cisco TelePresence Configuration
Problem
Possible Cause
Possible Solutions
