Canon imageRUNNER 2525 Series, Service Manual, Page: 246 / 402

Details of [Bit 3]
To set whether to display the Waste Toner Container preparation warning message in the status area of LUI.
Selecting "1" displays the warning. (Initial value)
Selecting "0" does not display the warning.
Details of [Bit 4]
To set whether to display the Toner Bottle replacement warning message in the status area of LUI.
Selecting "1" displays the warning. (Initial value)
Selecting "0" does not display the warning.
NOTE:
To notify the waste toner full warning in the status line of the Control Panel, set "1" for Bit 0 and Bit 3 of SW34.
● SSSW-SW35
Not used
Bit Function 1 0
0 e-RDS function ON/OFF Yes No
1 Call button function ON/OFF Yes No
2 ScanToMedia function enable/disable
Default: 0 enable disable
3 MediaPrint function enable/disable enable disable
4 IC card authentication management function ON/OFF Yes No
5 Handling of a scan job at device logout
Default: 0 Stop a scan job Not stop a scan job
6 Handling of display of the stop confirmation screen when the
stop key is pressed during a scan job, except remote scan Not display the stop confirmation
screen (same specification as
that of the existing models) Display the stop confirmation
screen (the display specification
following that of the iR series)
7 Switching to display/hide the start button of the counter print
(known as billing counter report)
Default: 1 Display the counter print button Hide the counter print button
Detailed Discussions of Bit 0
Select whether to set the e-RDS function.
When "1" is selected, the function is set.
When "0" is selected, the function is not set.
Detailed Discussions of Bit 1
Select whether to enable the service call request function and display the Service Call Request button.
When "1" is selected, the function is enabled and the button is displayed.
When "0" is selected, the function is disabled and the button is not displayed.
CAUTION:
In the case of a model for USA, the button will not be displayed even if "1" (enabled) is selected.
Detailed Discussions of Bit 2
Select whether to enable or disable the ScanToMedia function.
When "1" is selected, the function is enabled.
When "0" is selected, the function is disabled.
Detailed Discussions of Bit 3
Select whether to enable the MediaPrint function.
When "1" is selected, the function is enabled.
When "0" is selected, the function is disabled.
8. Service Mode
236