BinTec X3200, User Manual

Page: 29 / 419

X3200 User’s Guide 29
2
2 General Safety Precautions
General Safety Precautions in English
The following sections contain safety precautions you are strongly advised to
heed when working with your equipment.
Transport and storage
■
Only transport and store X3200 in its original packaging or use other appro-
priate packaging to protect against knocking and shaking.
Installation and
operation
■
Read the information on the ambient conditions (see Technical Data) be-
fore installing and operating X3200 . Place the equipment on a firm flat
base.
■
Condensation may occur externally or internally if the equipment is moved
from a colder room to a warmer room. When moving the equipment under
such conditions, allow ample time for the equipment to reach room temper-
ature and to dry out completely before operating. Observe the ambient con-
ditions under Technical Data.
■
Make sure the nominal voltage on the label of the mains unit is the same as
the local power source.
■
Make sure you follow the correct cabling sequence, as described in the
manual. Firstly, connect the LAN, ISDN and serial cables, then connect to
the mains, and finally, turn on your X3200 .
■
Make doubly sure the cabling is correct – especially the ISDN and LAN ca-
bles – before you turn on X3200 . X3200 ’s ISDN connection must not be
connected to the Ethernet connection of your PC or hub, and X3200 ’s LAN
connection should not be connected to the ISDN connection.
■
Use only the cables supplied. If you use other cables, BinTec Communica-
tions AG cannot accept liability for any damage occurring or for any adverse
effects on operation.
■
Arrange the cables so that they are not in the way and cannot be tripped
over or damaged.
■
Do not connect, disconnect or touch the data lines during lightning storms.