BinTec X3200, User Manual

Page: 329 / 419

X3200 User’s Guide 329
Typical Errors
9
➤
Log in as the user
admin
with the corresponding password.
➤
Start the Setup Tool with
setup
.
➤
Check if a configuration error is the cause:
Have you entered the IP address under
CM-100BT, F
AST
E
THERNET
?
Have you entered a filter under
IP
➧
A
CCESS
L
ISTS
that is locking you out?
Have you activated NAT for an Ethernet interface (en1 or en1-snap) under
IP
➧
N
ETWORK
A
DDRESS
T
RANSLATION
➧
E
DIT
and forgotten to allow the
required IP connections for this interface under IP
➧
N
ETWORK
A
DDRESS
T
RANSLATION
➧
E
DIT
➧
ADD.
If so, make the required corrections.
If a serial connection does not work either:
➤
Check the settings of the terminal program (see chapter 4.1.1, page 83 ). If
you have changed the default settings in BOOTmonitor, adjust your termi-
nal settings accordingly.
➤
If this does not succeed, proceed as explained under "I have forgotten my
password".
9.2.2 ISDN Connections
Here you will find possible causes of errors in ISDN connections.
Your telephone bill is unusually high.
In case of ISDN connections on X3200 remaining open or unwanted ISDN con-
nections being established:
➤
Use
debug all
or
trace
to check if a PC in the LAN is using a different
netmask from the one entered on X3200 .
➤
Use
debug all
or
trace
to check if a PC in the LAN is configured for Re-
mote CAPI with an incorrect IP address (destination port 2662).
Use the Credits Based Accounting System (see chapter 7.1.3, page 268 ). This
enables you to set a limit for connections to X3200 to prevent unnecessary
charges accumulating as a result of mistakes made during configuration.