BinTec X3200, User Manual

Page: 170 / 419

170 BinTec Communications AG
Basic Configuration with the Setup Tool
5
Configuration of PC in
Windows NT
The necessary steps for configuration of your PC or laptop if you use the Win-
dows NT operating system are given below. If you use Windows 95 or 98, you
must observe basically the same points to complete the configuration success-
fully using the list.
The following steps are necessary:
■
Installing the ISDN/GSM card or modem together with the relevant data
communications driver. (Refer to the documentation supplied with the card
or modem and follow the instructions on the screen.)
■
Check whether the TCP/IP protocol is installed (in the Windows Start menu
under Settings
➧
Control Panel
➧
Network) or install this protocol if
necessary (see chapter 3.2.2, page 38 ).
■
Check the installed card (in the Network Card tab).
■
Check whether the RAS service is installed and install if necessary (in the
Services tab).
■
Leave the Network menu with OK. The TCP/IP protocol is fixed on the dial-
up adaptor. When the installation is successfully completed, the virtual mo-
dems are listed (Settings
➧
Control Panel
➧
Modems).
■
Make a new entry for the connection in the directory (Program
➧
Accessories
➧
DCN). The telephone number must be entered under
which X3200 accepts routing calls.
■
Check the directory entry (Continue
➧
Edit Entry and Modem Parame-
ters in the Entries tab).
■
Only TCP/IP is to be selected as network protocol in the Server tab.
■
Create connection (Select).
■
Entering user name and password (= Partner PPP ID and PPP Password
under WAN P
ARTNER
➧
ADD
➧
PPP in X3200 ).
■
The connection is set up on leaving the menu by pressing OK.
If you want to dial in to a Windows network, you must carry out a few additional
configuration steps.