BinTec X3200, User Manual

Page: 95 / 419

X3200 User’s Guide 95
Configuration options
4
Example:
In the
WAN P
ARTNER
menu shown above, the entries provide the following
search results:
Table 4-4: Search results
Changing the
password
The procedure described below for changing the password applies to all X3200
passwords: the access passwords for the user names
admin
,
read
and
write
, the HTTP password, the PPP password and the provider password.
Any character may be used for entering a password. Passwords are only dis-
played as asterisks, even during password changes. The number of asterisks
is the same as the number of characters in the password.
To change a password, proceed as follows:
If the search does not work, make sure that the cursor is located in a list field.
The search cannot run if the cursor is located in a command field, e.g. ADD or
DELETE.
Entry Cursor moves to entry
p
or
P
Partner1
pr
,
Pr
,
pR
,
PR
PROVIDER
p a r t n e r 2
Partner1, on entering
2
to Partner2
To start the X3200 Setup Tool in a mode in which the passwords are displayed
in plain language and can be changed once by editing, you must enter the
command
setup -p
. This option only exists if you have logged in on X3200
under the user name
admin
.
In the password field, the Backspace key always deletes the complete entry
and not just one character.