BinTec X3200, User Manual

Page: 33 / 419

X3200 User’s Guide 33
Setting Up and Connecting
3
Make the connections in the following order:
➤
Place X3200 on a firm level surface or mount it in a 19" rack.
➤
Connect the serial port of your PC (COM1 or COM2) to the serial interface
of your router (8, cf.
figure 3-1, page 32 ). Use only the serial cable (gray)
supplied with the equipment.
You can connect X3200 to your hub (LAN) or to the network card of your PC
(single-user system).
To connect X3200 to your LAN, you need the red LAN cable supplied with the
equipment.
➤
Connect the LAN interface (marked red) of X3200 (10) to your LAN.
The speed of your LAN (10 Mbps or 100 Mbps) is detected automatically
(auto sensing).
Alternatively, you can connect X3200 to the network card of your PC or, if you
belong to a small network, to a hub. You only need to make sure you use the
right cables.
Connect X3200 to the ISDN over the ISDN connection (4). It makes no differ-
ence to X3200 whether you use an ISDN socket, an
➤➤
NTBA adaptor or a
PABX. If, however, you want to use functions specific to a PABX, connect
X3200 to the PABX. This enables you to disable extensions, for example, so
that these never reach X3200 at all. Or you can check the charges for the ex-
tensions you assign to X3200 .
Caution!
Incorrect cabling of ISDN or LAN interfaces can cause your router to malfunc-
tion!
➤
Only connect the LAN interface of X3200 to the LAN interface of your PC/
hub and the ISDN interface of X3200 to the ISDN connection.