BinTec X3200, User Manual

Page: 169 / 419

X3200 User’s Guide 169
X3200 and the WAN
5
➤
Enter Pool ID, e.g. 1 .
➤
Enter IP Address (= IP address of your dial-in partner), e.g.
100.100.100.1
.
➤
Enter Number of Consecutive Addresses, e.g. 1 .
➤
Press SAVE.
➤
Leave IP
➧
IP A
DDRESS
P
OOL
WAN (PPP) with EXIT.
➤
Leave IP with EXIT.
Entering extensions
➤
Go to
CM-1BRI, ISDN S0
➧
I
NCOMING
C
ALL
A
NSWERING
➧
A
DD
.
➤
Select Item: PPP (routing).
The setting PPP (routing) automatically detects the protocol used (e.g.
ISDN 64 kbps or V110 (9600) ).
➤
Enter Number, e.g. 1234567 (= telephone number over which the dial-in
partner is to dial in).
➤
Select Mode: right to left.
➤
You can leave Username empty.
➤
Select Bearer: any.
➤
Press SAVE.
➤
Leave ICM-1BRI, ISDN S0
➧
I
NCOMING
C
ALL
A
NSWERING
with EXIT.
➤
Confirm
with SAVE.
Nokia Communicator If you use a Nokia Communicator mobile phone, you must make the following
additional entries to enable the mobile phone to set up a connection to the cor-
porate network:
➤
Go to
PPP..
➤
Activate PPP Link Quality Monitoring: yes.
➤
Go to W
AN
P
ARTNER
➧
A
DD
➧
PPP.
➤
Activate Link Quality Monitoring: on.
Enter only your extension without prefix under Number. If X3200 is connected
to a PABX, you must only enter the PABX extension number that X3200
receives. (You should also refer to the information in chapter 5.1.4, page 112 ).