BinTec X3200, User Manual

Page: 84 / 419

84 BinTec Communications AG
Connecting X3200
4
Unix If you are using a Unix PC, you equally need a terminal program such as cu (un-
der System V), tip (under BSD) or minicom (under Linux). The settings for
these programs are the same as listed above.
If the login prompt does not appear after pressing Return several times, the
connection to
X3200 has not been set up successfully. Check the settings of
COM1 or COM2:
➤
Click File
➧
Properties.
➤
Click Configure.... in the Connect To tab.
The following settings are necessary:
– Bits per second: 9600
– Data bits: 8
– Parity: none
– Stop bits: 1
– Flow control: none
➤
Enter the values and click OK.
➤
Set in the Settings tab:
– Emulation: VT100
➤
Click OK.
The changes to the terminal program settings do not take effect until you dis-
connect the connection to X3200 and then make the connection again.
You can also use any other terminal program that can be set to 9600 bps, 8N1
(8 data bits, no parity, 1 stop bit), software handshake (none) and VT100 emu-
lation.