BinTec X3200, User Manual

Page: 347 / 419

X3200 User’s Guide 347
BOOT Sequence
10
BOOTmonitor If you want to use the BOOTmonitor functions, press the Space bar within 4
seconds of the BOOTmonitor prompt appearing ( figure 10-6, page 346 ). If you
do not make an entry within 4 seconds, X3200 changes back to Normal Mode.
Functions The BOOTmonitor provides the following functions, which you can select by en-
tering the relevant digit (for more detailed information, refer to the Software
Reference):
■
(1) Boot system:
X3200 loads the compressed boot file from the flash memory to the RAM
memory. This happens automatically when started.
■
(2) Software update via TFTP:
X3200 performs a software update via a TFTP server.
■
(3) Software update via XMODEM:
X3200 performs a software update over a serial interface with XMODEM.
■
(4) Delete configuration:
X3200 is reset to the unconfigured ex works state. All configuration files are
deleted and the BOOTmonitor settings are set to the default values.
■
(5) Default BOOTmonitor parameters:
You can change the default settings of X3200 ’s BOOTmonitor, e.g. the
baud rate for serial connections.
If you change the baud rate (the preset value is 9600 bauds), make sure the
terminal program used also uses this baud rate. If this is not the case, you will
not be able to establish a serial connection to
X3200 !