BinTec X3200, User Manual

Page: 115 / 419

X3200 User’s Guide 115
Basic Router Settings
5
To do To enter the settings of your ISDN connection, proceed as follows:
➤
Select ISDN Switch Type: autodetect on bootup.
This setting enables X3200 to use its automatic D-channel detection. As
long as the D-channel detection is running,
running appears next to Result
of Autoconfiguration. Once the setting has been found, it is displayed,
e.g.
Euro ISDN, point-to-multipoint .
➤
Select B-Channel 1: dialup.
➤
Select B-Channel 2: dialup.
➤
Press SAVE.
You have returned to the main menu. and the entries have been saved.
Incoming Call
Answering
If you use the WAN interface for dialup connections, you must now tell X3200
how it should respond to incoming calls from the ISDN and how it is to handle
outgoing calls. (These settings are not necessary for leased lines.) X3200 dis-
tributes the incoming calls to the appropriate internal services according to the
settings in the following menus.
X3200 supports the following services:
■
PPP (routing)
The
➤➤
PPP service is X3200 ‘s general routing service. It connects in-
coming data calls from WAN partners’
➤➤
dialup connections to your
➤➤
LAN . This enables partners outside your own local network to ac-
cess hosts within your LAN.
If you are using a leased line or the ISDN protocol is not detected, it can be
entered manually under ISDN Switch Type. The automatic D-channel detec-
tion is then switched off.
An incorrectly set ISDN protocol prevents ISDN connections being set up!
In most cases, you can accept the preset values for D-Channel, B-Channel 1
and B-Channel 2.
If you use an ISDN leased line and have requested a special service from your
service provider, it may be necessary to set the local side of the leased line at
this point (DTE or DCE).