BinTec X3200, User Manual

Page: 152 / 419

152 BinTec Communications AG
Basic Configuration with the Setup Tool
5
Table 5-20: Network
Default route To define a default route, proceed as follows:
➤
Select Route Type: Default route.
➤
Select Network: WAN without transit network.
➤
Select Partner / Interface: e.g. GoInternet .
➤
Enter Metric, e.g.
1
.
➤
Press SAVE.
You have returned to IP
➧
R
OUTING
. The entries have been saved and the
newly entered or modified route is listed.
WAN with transit network Route to a destination host or LAN that can be
reached via a WAN partner with transit net-
work.
Refuse X3200 discards data packets using this route
and sends the sender a message saying the
destination of the packet is unreachable.
Ignore X3200 discards data packets using this route
without sending a status message.
Possible Values Meaning
You can only configure one default route on your X3200 . If you set up access to
the Internet, you must therefore configure the route to your Internet Service Pro-
vider (ISP) as a default route.
If you configure a corporate network connection, only enter the route to the head
office as a default route if you do not configure Internet access over X3200 .
If you configure both Internet access and a corporate network connection, enter
a default route to the ISP and a network route to the head office.
The corporate network can consist of several LANs with different network IP
addresses and netmasks (
➤➤
subnets ). That is, if you do not enter your
head office access as a default route (e.g. because you have already set up
your Internet access as a default route), then you must make a separate rout-
ing entry for each network you want to reach at the head office.