BinTec X3200, User Manual

Page: 195 / 419

X3200 User’s Guide 195
Settings Specific to WAN Partners
6
You will find all the necessary steps below for configuring X3200 for AO/DI with
the Setup Tool.
X.31 configuration Proceed as follows to assign X.31/X.25:
➤
Go to CM-1BRI, ISDN S0
➧
A
DVANCED
S
ETTINGS
(the menu is described
in chapter 6.1.4, page 182 ).
➤
Select X.31 TEI Value:
specify.
➤
Enter Specify TEI Value: 1.
➤
Select X.31 TEI Service: Packet Switch.
➤
Press SAVE.
You have returned to the CM-1BRI, ISDN S0 menu.
➤
Press SAVE.
You have returned to the main menu. The main menu now contains the
X.25 menu, which you need for the following configuration steps. Informa-
tion about the X.25 parameters can be found in the Software Reference at
www.bintec.net .
X.25 configuration Proceed as follows to make the preset link settings for X.25 configuration for
Datex-P:
➤
Go to
X.25
➧
L
INK
C
ONFIGURATION
.
➤
Select the interface for which you want to configure X.25, e.g. x31d2-0-1 .
The following parts of the menu are relevant for this configuration step:
The default setting for X.31 TEI Value should be specify. If this is not the case,
the X.31 service has not been detected by autoconfiguration and this service is
probably not supported (contact your telephone provider).
Field Meaning
L3 Packet Size Permissible size of data packets for this con-
nection on the third layer of the OSI model.