575
32072H–AVR32–10/2012
AT32UC3A3
• Write a one to CR.TXEN and CR.RXEN to enable both transmitter and receiver
• Wait until CSR.TXRDY is one
• Send the header by writing to LINIR.IDCHR
The following procedure depends on the LINMR.NACT setting:
• Case 1: LINMR.NACT is 0x0 (PUBLISH, the USART transmits the response)
– Wait until CSR.TXRDY is one
– Send a byte by writing to THR.TXCHR
– Repeat the two previous steps until there is no more data to send
– Wait until CSR.LINTC is one
– Check for LIN errors
• Case 2: LINMR.NACT is 0x1 (SUBSCRIBE, the USART receives the response)
– Wait until CSR.RXRDY is one
– Read RHR.RXCHR
– Repeat the two previous steps until there is no more data to read
– Wait until CSR.LINTC is one
– Check for LIN errors
• Case 3: LINMR.NACT is 0x2 (IGNORE, the USART is not concerned by a response)
– Wait until CSR.LINTC is one
– Check for LIN errors
Figure 25-33. Master Node Configuration, LINMR.NACT is 0x0 (PUBLISH)
Frame
Break
Synch
Protected
Identifier
Data 1
Data N
Checksum
TXRDY
Write
THR
Write
LINIR
Data 1
Data 2
Data 3
Data N-1
Data N
RXRDY
Header
Inter-
frame
space
Response
space
Frame slot = TFrame_Maximum
Response
Data3
LINTC
FSDIS=1
FSDIS=0
Summary of Contents for AT32UC3A3128
Page 61: ...61 32072H AVR32 10 2012 AT32UC3A3 PLLEN PLL Enable 0 PLL is disabled 1 PLL is enabled...
Page 592: ...592 32072H AVR32 10 2012 AT32UC3A3 Manchester Configuration Register on page 614...
Page 989: ...989 32072H AVR32 10 2012 AT32UC3A3 37 2 Package Drawings Figure 37 1 TFBGA 144 package drawing...
Page 991: ...991 32072H AVR32 10 2012 AT32UC3A3 Figure 37 3 VFBGA 100 package drawing...
