Agilent Technologies E5070B, User Manual

Page: 295 / 769

Chapter 7 289
Fixture Simulator
Determining Characteristics After Adding a Matching Circuit
7
. F
ixt
ur
e
Sim
ula
to
r
Step 5. Press
Select Circuit
.
Step 6. Select a matching circuit model (Figure 7-5).
Softkey Function
None
No matching circuit is added.
Series L - Shunt C
Selects a circuit model consisting of a series inductor and a shunt
capacitor
Shunt C - Series L
Selects a circuit model consisting of a shunt capacitor and a series
inductor
Shunt L - Series C
Selects a circuit model consisting of a shunt inductor and a series
capacitor
Series C - Shunt L
Selects a circuit model consisting of a series capacitor and a shunt
inductor
Shunt L - Shunt C
Selects a circuit model consisting of a shunt inductor and a shunt
capacitor
User
Selects the circuit model defined in the user file imported by
performing Step 4
Step 7. Specify the values of the elements in the selected circuit model.
Softkey Function
C
Specifies capacitance [F]
G
Specifies conductance [S]
L
Specifies inductance [H]
R
Specifies resistance [
Ω
]
NOTE When either of the two components of Series-C, "C" and "G", is set to 0, the component is
defined as "Open"; when both components are set to 0, they are defined as "Short."
When either of the two components of Shunt-L, “L” and “R”, is set to 0, the component is
defined as "Short"; when both components are set to 0, they are defined as "Open."
Step 8. Repeat Step 3 to Step 7 to set up the matching circuit for each port used.
Step 9. Press
Port Matching
to turn the matching circuit function
ON
.
Step 10. Press
Return
.
Step 11. If
Fixture Simulator
is
OFF
, press the key again to turn it
ON
.