Installing Pluggable Transceivers
248
Installation and Commissioning Manual
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
Installation Procedure
Several tasks must be completed. Some tasks are detailed in sub-tasks. Follow
these steps to install a CFP transceiver in the interface cage of a CFP-based
channel module.
Procedure
Step 1
Read the installation plan to get information about:
•
the CFP transceiver type that is to be installed
•
the channel module which is to hold this transceiver
•
the cage where this transceiver is to be inserted in (if the channel
module has two interface cages).
Step 2
Check the operating status of the equipment and the present hazard
level. Please keep in mind that the laser hazard level of the network
element will be influenced when any module is operating in "Forced
On" mode. Do not proceed unless you are familiar with the laser
safety and you are protected accordingly.
Step 3
Attach a wrist strap to your bare wrist and fasten the grounding cable
onto the ESD grounding point on the shelf (if available) or to a bare
metal surface onto the rack.
Step 4
If mounted, remove the front cover from the shelf, as described in
“Removing the SH7HU or SH9HU Front Cover” on p. 259
.
Step 5
Find the physical location of the channel module that is to hold the
CFP transceiver.
Step 6
Take the CFP transceiver module out of the shipping box. Remove
the module from the antistatic bag and immediately put it onto a
grounded surface or an antistatic mat.
P
S
Note
Do not remove the optical port dust cover until directed to do so later
in the procedure.