Chapter 5 Installing Shelves
Installation and Commissioning Manual
195
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
Step 4
The support person should grasp the shelf underneath the lower edge
and lift with both hands. The shelf should be positioned so the
attached brackets in the rack are aligned with the bracket holes on
each side of the rack.
Step 5
Insert two rack screws with washers on each side of the shelf into the
holes.
Step 6
Tighten the rack screws completely with an appropriate screwdriver.
End of Procedure
Rack-Mounting the DCF1HU-P Shelf
The FSP 3000R7 DCF1HU-P Shelf can be mounted into open equipment racks
or customer cabinets of the following standard widths: 19 inch, 21 inch and 23
inch. They also fit into a 300 mm (0.984 ft.) deep ETSI rack.
Each DCF1HU-P Shelf comes pre-installed with 19-inch brackets. If a
DCF1HU-P Shelf is to be mounted into an ETSI or NEBS compliant rack, you
must remove the 19-inch brackets and fit the appropriate adaptor bracket pair.
The ETSI and NEBS brackets are fitted on the outside of the left-hand and
right-hand side walls. The adaptor bracket pairs are delivered with the equip-
ment.
The procedures for fitting the adaptor brackets and mounting the shelf to the
rack are described in the following subsections.
This section contains the following subsections:
Specialized Knowledge Required
Fitting the DCF1HU-P Shelf with 19-inch, NEBS or ETSI Brackets
Specialized Knowledge Required
Specialized knowledge is not required for fitting the adaptor brackets and
mounting a DCF1HU-P Shelf into a rack.
Fitting the DCF1HU-P Shelf with 19-inch, NEBS or
ETSI Brackets
This subsection describes the procedure that must be followed in order to fit the
DCF1HU-P shelf with 19-inch, NEBS or ETSI brackets.
19-inch brackets are required to adapt the DCF1HU-P shelf to the 19-inch stan-
dard rack dimensions. NEBS brackets are required to adapt the DCF1HU-P