ABB ACS280, Firmware Manual, Page: 33 / 430

Program features 33
Adaptive program fault and aux code formats
The format of the aux code:
If the state number is zero but the block number has a value, the fault is related
to a function block in the base program. If both state number and block number
are zero, the fault is a generic fault that is not related to a specific block.
Sequence program
An adaptive program can contain base program and sequence program parts.
Base program is run continuously when adaptive program is in running mode.
Acceleration time 1 23.12 Acceleration time 1
Deceleration time 1
23.13 Deceleration time 1
Frequency control
Ext1 frequency reference
28.11 Ext1 frequency ref1
Torque control
Ext1 torque reference
26.11 Torque ref1 source
Ext2 torque reference 26.12 Torque ref2 source
Limit function
Minimum torque 2 30.21 Min torque 2 source
Maximum torque 2
30.22 Max torque 2 source
Events
External event 1
31.01 External event 1 source
External event 2 31.03 External event 2 source
External event 3
31.05 External event 3 source
External event 4 31.07 External event 4 source
External event 5
31.09 External event 5 source
Data Storage
Data storage 1 real32
47.01 Data storage 1 real32
Data storage 2 real32 47.02 Data storage 2 real32
Data storage 3 real32
47.03 Data storage 3 real32
Data storage 4 real32 47.04 Data storage 4 real32
Process PID
Set 1 setpoint 1 40.16 Set 1 setpoint 1 source
Set 1 setpoint 2
40.17 Set 1 setpoint 2 source
Set 1 feedback 1 40.08 Set 1 feedback 1 source
Set 1 feedback 2
40.09 Set 1 feedback 2 source
Set 1 gain 40.32 Set 1 gain
Set 1 integration time
40.33 Set 1 integration time
Set 1 tracking mode
40.49 Set 1 tracking mode
Set 1 track reference
40.50 Set 1 tracking ref selection
Bits 24-31: State number Bits 16-23: block number Bits 0-15: error code
Outputs available to the adaptive program
Output Target