ABB ACS280, Firmware Manual, Page: 250 / 430

250 Parameters
46.13 Filter time motor
torque
Defines a filter time for signal
01.10 Motor torque
. 100 ms
2…20000 ms Motor torque signal filter time. 1 = 1 ms
46.14 Filter time power
Defines a filter time for signal
01.14 Output power
. 100 ms
2…20000 ms Output power signal filter time. 1 = 1 ms
46.21 At speed hysteresis
Defines the “at setpoint” limits for speed control of
the drive.
When the difference between reference (
22.87 Speed
reference act 7
) and the speed (
24.02 Used speed
feedback ) is smaller than 46.21 At speed hysteresis ,
the drive is considered to be “at setpoint”. This is
indicated by bit 8 of
06.11 Main status word
.
50.00 rpm
0.00…30000.00 rpm Limit for “at setpoint” indication in speed control. See par.
46.01
46.22 At frequency hysteresis
Defines the “at setpoint” limits for frequency control
of the drive. When the absolute difference between
reference (
28.96 Frequency ref ramp input
) and actual
frequency (
01.06 Output frequency
) is smaller than
46.22 At frequency hysteresis
, the drive is considered
to be “at setpoint”. This is indicated by bit 8 of
06.11
Main status word
.
2.00 Hz
0.00…1000.00 Hz Limit for “at setpoint” indication in frequency control. See par.
46.02
No. Name/Value Description Default
FbEq 16
24.02
(rpm)
0 rpm
22.87
+
46.21
(rpm)
22.87
(rpm)
22.87 - 46.21 (rpm)
Drive at setpoint
(
06.11
bit 8 = 1)
01.06
(Hz)
0 Hz
28.96
+
46.22
(Hz)
28.96 (Hz)
28.96
-
46.22
(Hz)
Drive at setpoint
(
06.11
bit 8 = 1)