ABB ACS280, Firmware Manual, Page: 210 / 430

210 Parameters
32.61 Supervision 6
hysteresis
Defines the hysteresis for the signal monitored by
signal supervision 6.
Note : This parameter applies to all selections of
parameter
32.55
, not just Hysteresis.
0.00
0.00…100000.00 Hysteresis. -
34
35 Motor thermal protection
Motor thermal protection settings such as
temperature measurement configuration, load curve
definition and motor fan control configuration.
See also section
Motor thermal protection
(page
74
).
35.01 Motor estimated
temperature
Displays the motor temperature as estimated by the
internal motor thermal protection model (see
parameters
35.50
…
35.55
). The unit is selected by
parameter
96.16 Unit selection
.
This parameter is read-only.
-
-60…1000 °C Estimated motor temperature. 1 = 1°
35.02 Measured temperature
1
Displays the temperature received through the source
defined by parameter 35.11 Temperature 1 source .
The unit is selected by parameter
96.16 Unit selection
.
This parameter is read-only.
-
-60…5000 °C, or
-76…9032 °F, or
0...5000 ohm
Measured temperature 1.
Note: With a PTC sensor, the unit is ohms.If the
measured temperature source selection (
35.11
) is PTC
analog I/O or PTC AI/DI Voltage divider tree, the
motor thermal protection function converts the
analog input signal (
35.14
) to PTC resistance value
(ohms), and shows it in this parameter. This is the
case even the parameter name and unit refer to
motor temperature (°C or °F). You cannot change the
unit to ohm for the time being (
96.16
).
1 = 1 unit
35.05 Motor overload level
Shows the motor overload level as a percentage of
the motor overload fault limit.See section
0.0
0.0...300.0% Motor overload level.
0.0% No motor overloading.
88.0% Motor overloaded to warning level.
100.0% Motor overloaded to fault level. 10 = 1%
35.11 Temperature 1 source
Selects the source from which measured temperature
1 is read.
Usually this source is from a sensor connected to the
motor controlled by the drive, but it could be used to
measure and monitor a temperature from other parts
of the process as long as a suitable sensor is used as
per the selection list.
Estimated
temperature
Disabled None. Temperature monitoring function 1 is disabled. 0
Estimated temperature Estimated motor temperature (see parameter
35.01
Motor estimated temperature
).
The temperature is estimated from an internal drive
calculation. It is important to set up the ambient
temperature of the motor in
35.50 Motor ambient
temperature
.
1
No. Name/Value Description Default
FbEq 16