ABB ACS280, Firmware Manual, Page: 190 / 430

190 Parameters
Supervision 1 Bit 0 of
32.01 Supervision status.
24
Supervision 2 Bit 1 of
32.01 Supervision status.
25
Supervision 3 Bit 2 of
32.01 Supervision status
. 26
Supervision 4 Bit 3 of
32.01 Supervision status
. 27
Supervision 5 Bit 4 of
32.01 Supervision status
. 28
Supervision 6 Bit 5 of
32.01 Supervision status
. 29
EFB MCW bit 7 Control word bit 7 received through the embedded
fieldbus interface.
32
Other [bit]
Source selection (see
Terms and abbreviations
). -
31.12 Autoreset selection
Selects faults that are automatically reset. The
parameter is a 16-bit word with each bit
corresponding to a fault type. Whenever a bit is set to
1, the corresponding fault is automatically reset.
The number and interval of reset attempts are
defined by parameters
31.14
…
31.16
.
WARNING! Before you activate the function,
make sure that no dangerous situations can
occur. The function resets the drive
automatically and continues operation after a fault.
Notes:
• The autoreset function is only available in external
control; see section Local and external control
locations
(page
26
).
• Faults related to the Safe torque off (STO) function
cannot be automatically reset.
The bits of this binary number correspond to the
following faults:
0000h
0000h…FFFFh Automatic reset configuration word. 1 = 1
31.13 Selectable fault
Defines the fault that can be automatically reset
using parameter 31.12 Autoreset selection , bit 10.
Faults are listed in chapter
Fault tracing
(page
327
).
Note: The fault codes are in hexadecimal. The
selected code must be converted to decimal for this
parameter.
0
0000h…FFFFh Fault code. 10 = 1
No. Name/Value Description Default
FbEq 16
Bit Fault
0 Overcurrent
1 Overvoltage
2 Undervoltage
3 AI supervision fault
4 Reserved
5 OverFrequency / Overspeed
6 Earth fault
7 Short circuit
8,9 Reserved
10 Selectable fault (see parameter
31.13 Selectable fault
)
11 External fault 1 (from source selected by parameter 31.01 External event 1 source )
12 External fault 2 (from source selected by parameter
31.03 External event 2 source
)
13 External fault 3 (from source selected by parameter
31.05 External event 3 source
)
14 External fault 4 (from source selected by parameter
31.07 External event 4 source
)
15 External fault 5 (from source selected by parameter 31.09 External event 5 source )