ABB ACS280, Firmware Manual, Page: 128 / 430

128 Parameters
In1P Start fwd; In2P
Start rev; In3 Stop
The sources of the start and stop commands are
selected by parameter
20.05 Ext1 in3 source
.The
source selected by parameters
20.03 Ext1 in1 source
and
20.04 Ext1 in2 source
determines the direction.
The state transitions of the source bits are
interpreted as follows:
Note: Parameter
20.02 Ext1 start trigger type
has no
effect with this setting.
6
Control panel Start; stop and direction commands through control
panel; when EXT1 is active. Applies also for PC-Tool
when it is connected via panel port.
11
Embedded fieldbus The start and stop commands are taken from the
embedded fieldbus interface.
Note: The start signal is always level-triggered with
this setting regardless of parameter
20.02 Ext1 start
trigger type
.
14
20.02 Ext1 start trigger type
Defines whether the start signal for external control
location EXT1 is edge-triggered or level-triggered.
Note: This parameter is not effective if a pulse-type
start signal is selected. See the descriptions of the
selections of parameter
20.01 Ext1 commands
.
Level
Edge The start signal is edge-triggered. 0
Level The start signal is level-triggered. 1
20.03 Ext1 in1 source
Selects source 1 for parameter
20.01 Ext1 commands
.
DI1
Always off 0 (always off). 0
Always on 1 (always on). 1
DI1 Digital input DI1 (
10.02 DI delayed status
, bit 0). 2
DI2 Digital input DI2 (
10.02 DI delayed status
, bit 1). 3
DI3 Digital input DI3 (
10.02 DI delayed status
, bit 2). 4
DI4 Digital input DI4 (
10.02 DI delayed status
, bit 3). 5
Supervision 1 Bit 0 of
32.01 Supervision status
. 24
Supervision 2 Bit 1 of
32.01 Supervision status
. 25
Supervision 3 Bit 2 of
32.01 Supervision status
. 26
Supervision 4 Bit 3 of
32.01 Supervision status
. 27
Supervision 5 Bit 4 of
32.01 Supervision status
. 28
Supervision 6 Bit 5 of 32.01 Supervision status . 29
Other [bit] Source selection (see Terms and abbreviations ). -
20.04 Ext1 in2 source Selects source 2 for parameter 20.01 Ext1 commands .
For the available selections, see parameter
20.03 Ext1
in1 source
.
DI2
No. Name/Value Description Default
FbEq 16
State of
source 1
( 20.03 )
State of
source 2
( 20.04
)
State of
source 3
( 20.05
)
Command
0 -> 1 Any 1 Start forward
Any 0 -> 1 1 Start reverse
Any Any 0 Stop