ABB ACS280, Firmware Manual, Page: 113 / 430

Parameters 113
11.04 DO force data
Contains the value of digit output that is used instead
of the connected signals if selected in parameter
11.03
DO force selection
. Bit 0 is the forced value for DO1.
This provides the possibility to test the drive
functionality
without the plant wiring. T
on
and T
off
delays are
passed.
0000h
0000h...FFFFh Forced values of digital outputs. 1=1
11.05 AO1/DO1 configuration Selects whether DIO1 is used as a digital output, or
analog output.
Analog
output
11.06 DO1 output source
Selects a drive signal to be connected to digital
output DO1.
Not
energized
Not energized Output is not energized. 0
Energized Output is energized. 1
Ready run Bit 1 of
06.11 Main status word
. 2
Enabled Bit 0 of
06.16 Drive status word 1
. 4
Started Bit 5 of
06.16 Drive status word 1
. 5
Magnetized Bit 1 of
06.17 Drive status word 2
. 6
Running Bit 6 of
06.16 Drive status word 1
. 7
Ready ref Bit 2 of
06.11 Main status word
. 8
At setpoint Bit 8 of
06.11 Main status word
. 9
Reverse Bit 2 of
06.19 Speed control status word
. 10
Zero speed Bit 0 of
06.19 Speed control status word
. 11
Above limit Bit 10 of
06.17 Drive status word 2
. 12
Warning Bit 7 of
06.11 Main status word
. 13
Fault Bit 3 of
06.11 Main status word
. 14
Fault (-1) Inverted bit 3 of
06.11 Main status word
. 15
Fault/Warning A warning or fault is active. 16
Overcurrent A drive is tripped to overcurrent fault. 17
Overvoltage A drive is tripped to overvoltage fault. 18
Drive temp A drive is tripped to drive temperature fault. 19
Undervoltage A drive is tripped to undervoltage fault. 20
Motor temp A drive is tripped to motor temperature fault. 21
No. Name/Value Description Default
FbEq 16
Bit Value
0 Force the value of this bit to DO1, if so defined in parameter
11.03 DO force
selection.
1...15 Reserved
Index Name Description
10 Digital output DIO pin used as digital output.
13 Analog output DIO pin used as Analog output.