ABB ACS280, Firmware Manual, Page: 276 / 430

276 Parameters
Supervision 4 Bit 3 of
32.01 Supervision status
27
Supervision 5 Bit 4 of
32.01 Supervision status
. 28
Supervision 6 Bit 5 of
32.01 Supervision status
. 29
Other [bit]
Source selection (see
Terms and abbreviations
). -
96.13 User set I/O mode in2
See parameter
96.12 User set I/O mode in1
.
not used
96.16 Unit selection
Selects the unit of parameters indicating power,
temperature and torque.
0b0000
0b0000...0b1111 Unit selection word. 1 = 1
96.51 Clear fault and event
logger
Clears all events from the drive’s fault and event logs. Done
Done 0 = No action. 0
Reset 1 = Resets (clears) fault and event logger. 1
96.54 Checksum action Selects how the drive reacts
• when
96.55 Checksum control word
, bit 8 = 1
(Approved checksum A): if the parameter
checksum
96.68 Actual checksum A
does not
match
96.71 Approved checksum A
, and/or
• when
96.55 Checksum control word
, bit 9 = 1
(Approved checksum B): if the parameter
checksum
96.69 Actual checksum B
does not
match
96.72 Approved checksum B
.
No action
No action No action taken. (The checksum feature is not in use.) 0
Pure event The drive generates an event log entry (
B686
Checksum mismatch
).
1
Warning The drive generates a warning (
A686 Checksum
mismatch
).
2
Warning and prevent
start
The drive generates a warning (
A686 Checksum
mismatch
).
Starting the drive is prevented.
3
Fault The drive trips on
6200 Checksum mismatch
. 4
No. Name/Value Description Default
FbEq 16
Bit Name Information
0 Power unit
(mechanical) 0 = kW
1 = hp
1 Reserved
2 Temperature
unit
0 = °C
1 = °F
3 Reserved
4 Torque unit 0 = Nm (N·m)
1 = lbft (lb·ft)
5…15 Reserved