ABB ACS 800 Series, Firmware Manual

Page: 47 / 340

Control panel
47
Function mode
In the Function Mode, you can:
• upload the drive parameter values and motor data from the drive to the panel.
• download group 1 to 97 parameter values from the panel to the drive.
1)
• adjust the contrast of the display.
The panel enters the Function Mode when you press the FUNC key.
How to upload data from a drive to the panel
Note:
• Upload before downloading.
• Ensure the firmware of the destination drive is the same (for example, standard
firmware).
• Before removing the panel from a drive, ensure the panel is in remote operating
mode (change with the LOC/REM key).
• Stop the drive before downloading.
Before upload, repeat the following steps in each drive:
• Setup the motors.
• Activate the communication to the optional equipment. (See parameter group 98
OPTION MODULES .)
Before upload, do the following in the drive from which the copies are to be taken:
• Set the parameters in groups 10 to 97 as preferred.
• Proceed to the upload sequence (below).
Step Action Press Key Display
1. Enter the Function Mode.
1 L -> 1242.0 rpm O
UPLOAD <=<=
DOWNLOAD =>=>
CONTRAST 4
2. Select the upload function (a flashing cursor indicates the
selected function).
1 L -> 1242.0 rpm O
UPLOAD <=<=
DOWNLOAD =>=>
CONTRAST 4
3. Enter the upload function.
1 L -> 1242.0 rpm O
UPLOAD <=<=
4. Switch to external control.
(No L on the first row of the display.)
1 -> 1242.0 rpm O
UPLOAD <=<=
DOWNLOAD =>=>
CONTRAST 4
1)
By default, the parameter groups 98, 99 and the results of the motor identification are not included. The restriction
prevents downloading of unfit motor data. In special cases it is, however, possible to download all. For more information,
please contact your local ABB representative.
FUNC
ENTER
LOC
REM