3.6.11
Install the rigging pin through the rigging holes Figure 1 [22].
3.6.12
Install the input lever Figure 1 [2] in a 20° up position on the cam shaft Figure 1 [1] with the bolt
Figure 1 [6], two washers Figure 1 [5], the nut Figure 1 [3] and new Cotter pin Figure 1 [4].
3.6.13
Remove the rigging pin from the rigging holes Figure 1 [22].
3.6.14
Install the fuel flow transmitter, refer to AMM 12-B-73-30-01-00A-920A-A.
4
Close Up
4.1
Remove the spillage containers from below the engine.
4.2
Remove all the equipment, tools and materials from the work area. Make sure that the work area is
clean.
PC-12/47E AMM Doc No 02300, ISSUE 01 REVISION 26 MSN 545, 1001-1719,
1721-1999
12-B-AM-00-00-00-I
UNCLASSIFIED
Effectivity: All
12-B-71-00-00-00A-920A-B
UNCLASSIFIED
2021-12-04 Page 11
