ROM Cross Side Channel ID Test
Passed
Timer Test
Passed
ARINC 429 Hi Speed Test
Passed
ARINC 429 Lo Speed Test
Passed
Interprocessor Bus Not Operational
Passed
Configuration Module Test
Passed
Non-Volatile memory Test
Passed
4.38
Click the CLOSE button to show the CHOOSE ITEM TO VIEW screen.
4.39
Click the PART NUMBERS button to show the data for the ADAHRS Channel configuration.
4.40
Make sure that the Certification File ID agrees with the list given in AMM 12-B-00-00-00-00A-106A-A .
If the Certification File ID is not correct, load the Certification File (Step 2).
4.41
Click the CLOSE button to show the CHOOSE ITEM TO VIEW screen.
4.42
Click the AIRCRAFT INSTALLATION SETUP button.
4.43
Click the ADAHRS ALIGNMENT button.
4.44
Make a note of the ADAHRS PITCH, ROLL and HEADING OFFSET values shown in the closed fields
of the ADAHRS Mounting Installation screen.
Note
Do not make value entries or button selections in this step.
4.45
Make sure that the offset values are the same as those given on the placards located in the CD box in
the flight compartment.
Note
If one of the parameters is not the same as the value on the placard, enter the correct value and
click on SET ADAHRS PITCH/ROLL/HEADING OFFSET button. With all fields completed, click on the
STORE ADAHRS OFFSETS button. The Storing Data screen is shown: When the data is stored the
screen shows "SUCCESS!!". CLOSE this window. Do a compass swing after completing the Alignment
Check.
4.46
Make sure that the ADAHRS Mounting Direction box shows ADAHRS CONNECTORS POINTING
OUT LEFT OF AIRCRAFT.
Note
If the mounting direction is not correctly stored, enter the correct value and click on SET ADAHRS
MOUNTING DIRECTION button. With all fields completed, click on the STORE ADAHRS MOUNTING
DIRECTION button. The Storing Data screen is shown: When the data is stored the screen shows
"SUCCESS!!". CLOSE this window. Do a compass swing after completing the Alignment Check.
4.47
Click on the CLOSE button to return to the Installation Setup screen.
4.48
Click on the MAGNETOMETER ALIGNMENT button.
4.49
Make a note of the Magnetometer PITCH and ROLL OFFSET values shown in the closed fields of the
Magnetometer Mounting Installation screen.
Note
Do not make value entries or button selections in this step.
4.50
Make sure that the offset values are the same as those given on the placards located in the CD box in
the flight compartment.
PC-12/47E AMM Doc No 02300, ISSUE 01 REVISION 26 MSN 545, 1001-1719,
1721-1999
12-B-AM-00-00-00-I
UNCLASSIFIED
Effectivity: All
12-B-34-25-00-00A-903A-A
UNCLASSIFIED
2021-12-04 Page 8