1.20
Remove the nut Figure 3 [26] and the washer Figure 3 [25] from the bolt Figure 3 [23].
1.21
1.22
Remove and discard the lockwire from the bolt Figure 3 [27].
1.23
Hold the MLG leg Figure 3 [16] and remove the items that follow:
−
−
The washers Figure 3 [28] and Figure 3 [29]
−
The special washer Figure 3 [30]
−
The spacer Figure 3 [31] or Figure 3 [32] or Figure 3 [33] or Figure 3 [34].
1.24
Measure the thickness of the spacer Figure 3 [31] or Figure 3 [32] or Figure 3 [33] or Figure 3 [34].
1.25
Move the MLG leg Figure 3 [16] towards the rear spar until the bush Figure 3 [35] disengages from the
pin Figure 3 [36] and is clear of the front spar.
1.26
1.27
Remove the MLG leg Figure 3 [16] and spacer ring Figure 3 [21] from the structure.
2
Installation
Note
This procedure is applicable to the left and right Main Landing Gear (MLG).
Note
A minimum of two persons is recommended for this procedure.
2.1
Pre Installation Procedure
2.1.1
Put the items that follow in position on the MLG leg fitting:
−
The bush Figure 3 [35]
−
The special washer Figure 3 [30]
−
The washers Figure 3 [28] and Figure 3 [29].
2.1.2
Put the bolt Figure 3 [27] through the MLG leg fitting and push the bolt Figure 3 [27] hard against the
washers Figure 3 [28] and Figure 3 [29].
2.1.3
Use a Feeler gage (Pt.No. Local supply) to measure the clearance between the inner face of the MLG
leg and the inner surface of the special washer Figure 3 [30].
2.1.4
The clearance measurement, minus 0,1 mm, gives the thickness of the necessary spacer Figure 3 [31]
or Figure 3 [32] or Figure 3 [33] or Figure 3 [34] you must use.
2.1.5
Remove the items that follow from the MLG leg fitting:
−
−
The bush Figure 3 [35]
−
The special washer Figure 3 [30]
−
The washers Figure 3 [28] and Figure 3 [29].
2.1.6
Put a Spacer Figure 3 [31] or Figure 3 [32] or Figure 3 [33] or Figure 3 [34] of the correct thickness,
and the items that follow in position on the MLG leg fitting:
−
The bush Figure 3 [35]
−
The special washer Figure 3 [30]
−
The washers Figure 3 [28] and Figure 3 [29].
PC-12/47E AMM Doc No 02300, ISSUE 01 REVISION 26 MSN 545, 1001-1719,
1721-1999
12-B-AM-00-00-00-I
UNCLASSIFIED
Effectivity: All
12-B-32-10-01-00A-920B-A
UNCLASSIFIED
2021-12-04 Page 5