JBT FoodTech Frigoscandia GYRoCOMPACT M7, Руководство по установке

Страница: 87 / 288

1
1000-07-01GB-29-00
INSTALLATION
INSTALLATION MANUAL
Transfer area control
This document, together with the drawings,
gives the complete instructions for checking and
adjusting the transfer area.
Note!
Before adjusting the infeed rails, make sure that
the ball rails are correctly adjusted. Refer to
the drawing: “Check list” for the actual freezer.
If you adjust the ball rails at the outer transfer
point, check the freedom of movement of outer
ball chain tensioner.
Inner side
1. Check the clearance between the inner ball
chain and the belt foot. Do this where the
inner ball chain travels in under the belt, at
the ball chain tensioner.
2. Check if the belt foot runs freely in rela-
tion to the inner ball chain between the ball
chain tensioner and the collapse point (0°).
3. Check that there is a clearance between the
inner infeed rail and the belt mesh after the
collapse point. The ball chain should carry
the belt.
Contact
2
Clearance
Clearance
2
3
2
11. Before the collapse point at the inner rail.
1
Ball chain
tensioner’s
idler wheel
2-4 mm
1
10. At the inner ball tensioner’s idler wheel.
Contact
Clear
ance
12. After the collapse point at the inner rail.
3