JBT FoodTech Frigoscandia GYRoCOMPACT M7, Руководство по установке

Страница: 163 / 288

DOCUMENT NUMBER: 139-01GB-02 PAGE: 1/2
EQUIPMENT: GC
SERVICE INFO NUMBER: 139
REVISION DATE: MARCH , 2008
REVISED BY: JÖNSSOH
SERVICE INFORMATION
CURRENT RELAY SETTINGS
This service information contains information about the settings
and replacement of the current relays, used for low current
alarm of the heating.
The manufacturer has changed the design in June 2004 and
due to this the settings of the relay have been affected.
DIB01 current relay
Note!
From June 2004 the SJ155 is replaced by the new DIB01 relay.
Supply connection
For the DIB01 relay the supply connections are 11 and 10, for
24 VAC. See illustration 1.2.
Replacement
On some equipment the 1 - 5 A relay is installed with an exter-
nal shunt resistor. When replacing this relay, make sure to
remove the shunt resistor and use the 10 A version of the new
relay.
Setting
Set the front potentiometers as follows:
HYS = 10%
LEVEL = Current
DELAY = 1-3 sec.
To access the DIP switches open the grey plastic cover. Set the
DIP switches to the
!
-marked value, according to illustration 1.3.
1.1 The new DIB01 current relay.
N (-)
8 9
5
7
10 1
11 4 3 2
48/230 VAC 24/115 VAC
µ
L
1.2 Supply connection DIB01.
10A Models
0.1 - 5 A Models
Relay working mode
ON: Normally De-energized*
OFF: Normally Energized
Power ON delay
ON: 6 s ± 0.5 s
OFF: 1 s ± 0.5 s*
Contact input
ON: Latch function enable
OFF: Inhibit function enable
Monitoring function
ON: Over current
OFF: Under current*
Relay working mode
ON: Normally De-energized*
OFF: Normally Energized
Measuring range
SW1 ON ON OFF
SW2 OFF ON ON
Power ON delay
ON: 6 s ± 0.5 s
OFF: 1 s ± 0.5 s*
Contact input
ON: Latch function enable
OFF: Inhibit function enable
Monitoring function
ON: Over current
OFF: Under current*
1A 2A 5A
1 2 3 4 5 6
ON
ON
1 2 3 4
1.3 DIP switch setting.