JBT FoodTech Frigoscandia GYRoCOMPACT M7, Руководство по установке

Страница: 79 / 288

1/8
INSTALLATION
1000 - 07 - 01 - 30 - 01 INSTALLATION MANUAL
ADJUSTMENT OF VERTICAL
TAKE-UP, ASCENDING STACK
This document contains information on how to
adjust the vertical take-up. For more information
see equipment drawings.
1. Function of belt take-up
There are two criterias that must be full filed to
make the take-up work in the way it is inteded.
1. The weights must be heavy enough to keep
the belt tense in the take-up.
The most critical point is at the lower fixed
roller (pos 1, illustration 1a). The belt hangs
down in a slope if the belt tension is to low.
2. The weights must keep the wire (pos 2,
illustration 1a) tense all the way through the
take-up’s stroke.
There must always be at least one weight
left on the active side when the take-up is in
its bottom position.
2. Long/ short belt switch
1. Hold the movable shaft in its top position
(see illustration 1a).
Position the top stopper (pos 1, illustration
1a) so that the belt length switch is actuated
when the shaft reaches this position.
2. Hold the moveable shaft in its bottom
position.
Position the bottom stopper (pos 2,
illustration 2a) so that the belt length switch
is actuated when the shaft reaches this
position.
Note: Make sure that the belt links does not
come in contact with the wall or the steel details.
3. Check function of the belt length switch.
2a: Take-up in top position.
Legend illustration a:
1. Top stopper
2. Bottom stopper.
3. Belt length switch.
=S
troke
S
troke
100 mm
2
1
Top
position
Bottom
position
3
2
1
1a: Take-up in bottom position.