JBT FoodTech Frigoscandia GYRoCOMPACT M7, Руководство по установке

Страница: 157 / 288

SERVICE INFORMATION
SERVICE INFO NUMBER:
342
EQUIPMENT:
GC FRIGoDRIVE
REVISION DATE:
APRIL, 2014
REVISED BY:
GÖRAN GRAMBY
1
342-01GB-00
TRANSFER AREA ADJUSTMENTS WHEN
INSTALLING BALL RAILS
In the past we have seen issues with incorrect transfer of stack
weight at the transfer area. Incorrect settings of rails has cre-
ated more than one transfer point (Dual Transfer).
This has caused failure and premature wear of chains and belts.
The purpose of this Service Info is to describe a common and
approved method to build, measure and adjust the belt stack
transfer area in Frigoscandia GYRoCOMPACT
®
Spiral Equip-
ment.
Definitions
- Level: When all stands and ball rails are adjusted to their
correct level (height) over the equipment zero level.
- Transfer or Transfer Point: Where incoming belt starts to
carry the stack weight.
Correct transfer
A correct rail setup can be seen in the picture below.
At the transfer point, the distance between the rails should be
equal to the belt link height. Before the transfer point the dis-
tance should be larger and after the transfer point the distance
should be smaller.
Picture 1. Correct rail setup
® = Registered trade mark of JBT FoodTech.
Subject to be changed without notice.