JBT FoodTech Frigoscandia GYRoCOMPACT M7, Руководство по установке

Страница: 118 / 288

8
INSTALLATION
1000-07-01GB-26-06
2. Push the mesh against the inside of the belt.
3. Apply the jaws over the free rods in the space created in
between mesh and the tension links on
FRIGoBELT Widebelt or the side links on FRIGoBELT. On
FRIGoBELT Widebelt TC belts the jaws should be applied
beside the centre pulling links towards the outer side of the
belt.
4. Release the mesh so it springs back on to the jaws.
Note!
Make sure the belt is compressed ~2 mm when the jaws are
tightened to the load cell. The load cell is opened 0.4 mm at the
maximum load 2000N.
Preparations
1. Place a noticeable mark on the outside of the outer side link
where the load cell is attached.
2. Connect the load cell to the logger.
3. Check the amount of tiers in the freezer. The measurement
will take the same amount of minutes as number of tiers
installed, if the belt is set to the correct speed.
4. Turn the power ON on the logger. Make sure the power led
turns green.
5. Make sure you have a pen and paper to write on.
6. Make sure you have a stop watch.
Start logging data
Note!
Check that no person is inside the freezer or around the in- and
outfeed when starting the belt.
1. Start the measurements by pressing the
Measure START
button on the logger. At the exact same time as the Meas-
ure START button is pressed, start your stop watch.
If a proximity switch is used this is not critical.
2. Start the belt.
3. Measure and make notes of the exact time interval from
starting the logger till the load cell is at the 0° point of the
belt stack. Referred as
Time #1
later on.
4. Measure and make notes of the exact time interval from
starting the logger till the load cell is at the transfer point.
Referred as Time #2 later on.
5. Measure and make notes of the exact time interval from
starting the logger till the load cell is at the 0° point of the
belt stack on first belt tier. Referred as
Time #3
later on.